The Glas-Col Digital Timer is a micro controller-based countdown interval timer with dig ital display. For use with mantles, heating tapes, ovens, and other resistive loads up to 10 amps. Also can be used with stirrers, vortexers, shakers, and other motor-driven lab oratory equipment up to 10 amps load capacity.
Four timing ranges may be selected from the front panel. At the completion of the timing cycle, a solid-state alarm will sound for 5 seconds. The power to the load receptacle is terminated at the end of the timing cycle. The timer will then reset to the preset starting- time. The timing cycle may be interrupted by pushing the start/stop button. Timing will resume from the stopping point when timing cycle is restarted.
Four timing ranges may be selected from the front panel. At the completion of the timing cycle, a solid-state alarm will sound for 5 seconds. The power to the load receptacle is terminated at the end of the timing cycle. The timer will then reset to the preset starting- time. The timing cycle may be interrupted by pushing the start/stop button. Timing will resume from the stopping point when timing cycle is restarted.
Unit of Measure
Electrical Requirements |
N/A Lighted on/off switch, circuit breaker protection, 3-wire grounded receptacle, and 3-wire line cord with molded plug |
Electrical Rating |
N/A 10 A @ 240 V, 2400 W |
Timing Ranges |
N/A 00:01 - 59:59 minutes: seconds 00:01 -23:59 hours: minutes 000.1 - 999.9 seconds 0001 - 9999 seconds |
Display |
N/A 4-digit, 1/2" LED |
Momentary Buttons |
N/A Two for time setting; one for start/stop |
Audible Indicator |
N/A Solid state alarm sounds for 5 seconds at the end of the timing cycle |
Finish |
N/A Foxtip Gray and Charcoal |
Lab Bench Case Dimensions (w x d x h) |
N/A 8 x 6 x 3 3/8 in |
